The installation method of basin drainage can generally be installed using the drainage component package, which is generally available in hardware stores. For the installation steps of basin drainage, please refer to the following four steps:

The first step, preparation – disassemble the main body lock nut in the assembly and wipe clean around the basin drain hole.

The second step, plug the main body – apply a circle of waterproof glass glue to the bottom of the water removal main body, and plug the main body into the drainage hole of the basin

The third step, lock the water body – put the basin on the countertop, install the lock nut from below, and lock the water body on the countertop

The fourth step, select the height – lift the lifting rod, lock the lock to the bottom of the lifting rod, and select the appropriate lifting height.

Next, Boyang Sanitary Ware will talk about the detailed steps for the installation of the basin water:

The drain installed in the basin is a bounce drain with overflow hole. The installation steps of other drains are similar to this.

1. Take out the drain.

2. Remove the fixing parts and flanges under the drainer.

3. When installing the basin, pay attention to pick up the basin and take out the flange of the drainer.

Fourth, fasten the flange of the drain on the basin.

5. After the flange is tightened, place the basin flat on the countertop, and the water outlet should be aligned with the mouth of the countertop. This is the key to the installation of the basin.

6. Wrap the raw material tape at the appropriate position of the drain to prevent water seepage.

Seven, when the basin is installed, the drainer should be aligned with the water outlet of the basin.

8. Put the drainer into the drain hole of the basin.

9. Align the drainer with the drain outlet of the basin.

10. When installing the basin, you must take out the retainer of the drain and screw it on the drain.

11. Use a wrench to fasten the drain.

12. After the installation of the basin water is completed, the water should be tested in the basin.